How do I connect the cables for the Automatic Tool Changer (ATC) on MM-1000?

last update: February 21, 2019

X-Axis Alignment for STEPCRAFT D.Series Machines

last update: February 3, 2020

Z-Axis Alignment for STEPCRAFT D.Series Machines

last update: February 3, 2020

How can I reset my Stepcraft UCCNC installation and Settings?

last update: February 23, 2019

Why is the Yellow dot not in the location I set on my work piece in UCCNC?

last update: September 13, 2018

Does the Automatic Tool Changer require an air compressor?

last update: May 5, 2017

Is there a video on installing and setting up the STEPCRAFT Automatic Tool Changer?

last update: May 5, 2017

What post processor do I use for Vectric programs (Aspire, VCarve, Cut 2d, Cut 3D, PhotoVCarve)?

last update: September 4, 2018

Can I cut carbon fiber on the STEPCRAFT CNC?

last update: May 2, 2017

If I order a STEPCRAFT with an Automatic Tool Changer, will you pre-install the tool rack and setup the software?

last update: May 2, 2017