Question 1

What does it mean when I get the "Select the motion controller device from the list" when I start UCCNC?

stepcraft · Accepted Answer

Sometimes when you start UCCNC you will get the “Select the motion controller device from the list” message box that pops up. This is either happening because your UC100 interface or USB cable is unplugged or the device driver did not properly install. This video will show you how to fix this.

If you are still have trouble after watching this video, please contact our support team at [email protected].

Question 2

How long do the brushes on my MM-1000 DI Spindle last?

Bobby Noble · Accepted Answer

On average you will see 125-150 hours of use on your MM-1000 DI spindle before you start to see signs that it is time to change them.

These signs can include:

sign 1
sign 2

You can order a replacement set from our website HERE.

What does it mean when I get the “Select the motion controller device from the list” when I start UCCNC?

What does it mean when I get the “Select the motion controller device from the list” when I start UCCNC?

How long do the brushes on my MM-1000 DI Spindle last?