What post processor do I use for Vectric programs (Aspire, VCarve, Cut 2d, Cut 3D, PhotoVCarve)?

    Browse: Home / FAQs / What post processor do I use for Vectric programs (Aspire, VCarve, Cut 2d, Cut 3D, PhotoVCarve)?
C

What post processor do I use for Vectric programs (Aspire, VCarve, Cut 2d, Cut 3D, PhotoVCarve)?

What post processor do I use for Vectric programs (Aspire, VCarve, Cut 2d, Cut 3D, PhotoVCarve)?

 

NOTE: These post processors will work for BOTH UCCNC and WIN-PC NC

From the dropdown list in Vectric programs, you will look for the following

If you have an Automatic Tool Changer: Stepcraft UCCNC ATC Arcs (mm) (*.txt)

If you do not have an Automatic Tool Changer: Stepcraft UCCNC Arcs (mm) (*.txt)

If you have an older version of Vectric software and the STEPCRAFT post processors are NOT in the dropdown list, please use the following:

 

If you have an Automatic Tool Changer: Mach2/3 ATC Arcs (mm) (*.txt)

If you do not have an Automatic Tool Changer: Mach2/3 Arcs (mm) (*.txt)

Categories: Software Troubleshooting, Vectric Software (Cut 2D, Cut 3D, V Carve)
Direct Link
Comments are closed.
«
»