Deskproto CAM Software

Working With Metals

Will the milling and laser tools work on other metals besides aluminum?

Yes, they will also machine brass and copper.  STEPCRAFT machines are only designed for machining of non-ferrous metals.  So you can not mill steel, stainless steel, etc.

Also note that the laser will NOT cut metals.  you can use it to engrave but it will NOT cut!


This really depends on the bit you are using and what the flute length is.  If you are using a bit with a 0.5″ flute length then your maximum thickness would be 0.5″.  Keep in mind that when you go thicker than 0.125″ thick aluminum, you have to be very careful to take care of chip evacuation. When your end mill starts to make a deep channel that is the width of the bit, then chips will fall in the channel and when the bit rotates, it can recut the chips causing excessive heat, chatter, welding of the chips to the tip of the bit or breaking the bit.  A way around this for deeper cuts is to create a pocket around the perimeter that is wider than the bit so if chips fall in the channel they are not “forced” into the wall by the cutter.  You should also use compressed air to continually blow the chips away from the bit and the channel.

We have successfully cut through 1″ thick aluminum blocks without a problem. Keep in mind that this is a CNC router and not a CNC mill, so it is not designed to be as aggressive with your feeds, speeds and pass depths.  Take care to not push the machine, spindle or end mill past its limits.



No, you do not need to use different spindles.  The main factor will be how fast the feed rate will be that you run and how much material you remove per pass.

If you with to run a light duty spindle like a Dremel 4000, you can run wood, plastics and metals just as well as if you were using a Kress 800W spindle. The only difference is that you will not be able to remove as much material and your feed rate will be slower the harder the material is.

Keep in mind that dedicated CNC spindles will have better quality bearings which will offer less runout and therefore a longer life span and higher accuracy.  Using the Dremel example, this device is not meant for hours and hours of prolonged use, nor is it made to have lots of pressure side loading the main shaft.  You will find that if you are not careful on the feed rate and pass depth that you will quickly wear out the bearings.

A router like the Dewalt DW611 will also cut all types of material, but as with the Dremel, the bearings are not as good as with a dedicated spindle so you can expect more runout with a router.  The STEPCRAFT HF500 is a purpose built spindle that was designed to work with all types of materials and has an excellent bearing system that provides very little runout and a much higher accuracy.

The bottom line is that you can pretty much cut whatever you like with just about any spindle.  You just need to be cautious on feed rates and pass depth.

No, the STEPCRAFT is only designed to cut non-ferrous metals like brass, aluminum and copper.  You might be able to engrave steel with the right engraving bit and proper speed and feed settings, but you can not cut it.

No. While there are some “general purpose” end mills that will cut aluminum, some end mills are designed specifically for plastic, foam, wood or other non-metal materials.